Unique Programming For Digital Pager Message Notification - NEC IntraMail UX5000 Manual

Message Notification

Unique Programming for Digital Pager Message Notification

1. Set up the system-wide options that apply to the digital pager callback number.
1.
47-01-07: D
2.
47-01-08: D
2. Set up the system-wide options that apply to digital pager callouts.
1.
47-01-09: W
2.
47-01-15: S
168 ◆ IntraMail Features
P C
IGITAL AGER ALLBACK
Set the Digital Pager Callback Number portion of the Message Notification callout number for a
digital pager.
- This is the portion of the callout number that is appended to the pager service number.
- By default, this option is X*M#, where:
X is the number of the extension that generated the notification.
* is a visual delimiter (to make the pager display easier to read).
M is the number of new messages in the extension's mailbox.
# is the digit normally used by the pager service for positive disconnect.
✔ By default, this option is X*M# .
D D
ELAY IN IALING IGITAL
Set the delay ( 0 - 99 seconds) that occurs just before IntraMail dials the
portion of the Message Notification callout number for a digital pager.
N ( 246)
BACK UMBER PAGE
- Set this delay so the pager service has enough time to connect to the digital pager before
sending the callback number. Your pager service may be able to help you determine the best
value for this option.
- When placing a digital pager notification, the UX5000:
- Seizes the line specified by Trunk Group Routing.
- Dials the user-entered notification number ( OP + N ).
- Waits the
47-01-08: D
- Dials the number entered in
- The UX5000 assumes that the notification number will complete dialing approximately 4
seconds after line seizure. This means that, by default, the Digital Pager Callback Number
will be dialed into the pager service about 13 seconds after line seizure.
✔ By default, the delay is 9 seconds.
B D P
AIT ETWEEN IGITAL
Set the minimum time ( 1 - 255 minutes) between unacknowledged or unanswered digital pager
Message Notification callouts.
- A subscriber acknowledges a digital pager notification by logging onto their mailbox.
- After this interval expires, IntraMail will try the callout again (for up to the number of times
set in
47-01-14: N
UMBER OF
- If the UX5000 dials the callout number and the pager service is busy, it will retry the number
in one minute.
✔ By default, this interval is 15 minutes.
P C U
END AGER ALLOUT NTIL
Enter 1 (Yes) to have IntraMail continue to retry a digital pager Message Notification callout until
the notification is acknowledged.
- If this option is disabled ( No ), IntraMail will retry a digital pager Message Notification the
number of times specified in
- This option does not apply to Message Notification callouts to normal numbers.
- A digital pager notification is considered acknowledged when the recipient logs onto the
mailbox.
- By default, this option is disabled.
N ( 246)
UMBER PAGE
P C N (
AGER ALLBACK UMBER PAGE
D D P
ELAY IN IALING IGITAL AGER
47-01-07: D
IGITAL
C A (
AGER ALLOUT TTEMPTS PAGE
C A (
ALLOUT TTEMPTS PAGE
A ( 248)
CKNOWLEDGED PAGE
47-01-14: N
UMBER OF
246)
47-01-07: D
C N (
ALLBACK UMBER PAGE
P C N (
AGER ALLBACK UMBER PAGE
246)
.
248)
C A (
ALLOUT TTEMPTS PAGE
UX IntraMail Manual
P C -
IGITAL AGER ALL
interval.
246)
.
246)
.
248)