47-01-07: Digital Pager Callback Number; 47-01-08: Delay In Dialing Digital Pager Callback Number; 47-01-09: Wait Between Digital Pager Callout Attempts - NEC IntraMail UX5000 Manual

Program 47: IntraMail
Options
● 1-60 Seconds.
Default
✔ 5 Seconds.
47-01-06:
This option is not used.

47-01-07: Digital Pager Callback Number

(Pager CBack)
Use this option to set the Digital Pager Callback Number portion of the Message Notification callout num-
ber for a digital pager. This is the portion of the callout number that is appended to the pager service number.
Normally, this option should be X*M#, where:
- X is the number of the extension that generated the notification.
- * is a visual delimiter (to make the pager display easier to read).
- M is the number of new messages in the extension's mailbox.
- # is the digit normally used by the pager service for positive disconnect.
● See
Options
● Digits (12 maximum, using 0-9, # and *)
● M (Number of messages - entered by pressing LK1 )
● No entry (Entered by pressing CLEAR).
● X (Extension number - entered by pressing LK2 )
IntraMail automatically replaces the X command with the number of the extension that initially
received the message.
Default
✔ X*M#.

47-01-08: Delay in Dialing Digital Pager Callback Number

(Pager Dial Delay)
Use this option to set the delay (0-99 seconds) that occurs just before IntraMail dials the Digital Pager Call-
back Number portion of the Message Notification callout number for a digital pager. Set this delay so the
pager service has enough time to connect to the digital pager before sending the callback number. Your
pager service may be able to help you determine the best value for this option (0-99 seconds). By default,
this option is 9 seconds. When placing a digital pager notification, the UX5000:
1. Seizes the trunk specified.
2. Dials the user-entered notification number (in OP + N ).
3. Waits the 47-01-08: Delay in Dialing Digital Pager Callback Number interval.
4. Dials the number entered in 47-01-07: Digital Pager Callback Number.
The UX5000 assumes that the notification number will complete dialing approximately 4 seconds after
trunk seizure. This means that, by default, the Digital Pager Callback Number will be dialed into the pager
service about 13 seconds after trunk seizure.
● See
Options
● 0-99 seconds
Default
✔ 9 seconds

47-01-09: Wait Between Digital Pager Callout Attempts

(Notify Pager Intvl)
Use this option to set the minimum time (1-255 minutes) between unacknowledged or unanswered digital
pager Message Notification callouts. (A subscriber acknowledges a digital pager notification by logging
onto their mailbox.) After this interval expires, IntraMail will try the callout again (for up to the number of
times set in 47-01-14: Number of Callout Attempts). By default, this interval is 15 minutes.
246 ◆ IntraMail Programming
M N (
ESSAGE OTIFICATION PAGE
M N (
ESSAGE OTIFICATION PAGE
for more.
165)
for more.
165)
UX IntraMail Manual