Figure 4-39: Installing An Extension Card In The Ext-2U - Eci Telecom NPT-1020 Installation And Maintenance Manual

NPT-1020 Installation and Maintenance Manual
C
AUTION: When installing a MPoE_12G card the total PoE power budget is up to 90 W.
To install an extension card in the EXT-2U platform:
1. Identify the Eslot in which you want to install the extension card, according to the site installation
plan.
2. Loosen the two screws on the Eslot cover and remove it.
3. Check that the extension card has not been physically damaged during shipment, and that the
antistatic protection bag of the original packaging is sealed.
4. Remove the extension card from its antistatic protection packaging and perform a visual inspection to
detect damage during shipping. Report any problems.
5. Hold the extension card handles and insert its rear end into the card guides.
6. Push the extension card in until the front of the card is flush with the front of the EXT-2U platform. If
resistance is felt, pull the card out and repeat the procedure.
7. Secure the card in place by fastening its two captive screws.
N
OTE: Extension cards support live insertion. They can be installed at any time without
affecting the existing traffic running on the NPT-1020 or EXT-2U.
ECI Telecom Ltd. Proprietary

Figure 4-39: Installing an extension card in the EXT-2U

Installing Equipment
4-38