Optical Fibers; Table 3-6: Traffic Cables Mating Connector Data For Ext-2U; Table 3-7: Optical Fibers And Mating Connector Data For Npt-1020 - Eci Telecom NPT-1020 Installation And Maintenance Manual

NPT-1020 Installation and Maintenance Manual

Table 3-6: Traffic cables mating connector data for EXT-2U

Module or card Interface type
PE1_63 E1 balanced (2.048
Mbps)
PM345_3E E3/DS-3 (34/45
Mbps)
DMCE1_32 E1 balanced (2.048
Mbps)
EM_10E
SM_FXO_8E FXO
SM_FXS_8E FXS/FXD
SM_EM_24W6E 2W, 4W, 2WE&M, or
4WE&M
SM_V24E V.24
SM_V35E V.35
SM_V35_V11 V.35, V.11
SM_CODIR_4E Codirectional 64 Kbps

3.5.8 Optical Fibers

Optical fibers can be prepared on site. The following table lists the type of cables and mating connectors
needed to prepare cables for each NPT-1020 module.
For each optical interface, ECI supplies patch cords with mating optical connectors already attached to the
fiber. Therefore, only the optical termination on the ODF side, which is installation-dependent, must be
installed on site.
The optical fibers for connecting to equipment installed in a given rack must enter the rack from the top, be
threaded through cable guides running along the rack side rails, and end at the FST. The FST must contain
enough fiber length for extracting modules from the NPT-1020 and for replacing fiber in case of damage
(splicing repairs).
When routing fibers, make sure to observe the minimum bending radius (35 mm).

Table 3-7: Optical fibers and mating connector data for NPT-1020

I/O module Interface type
NPT-1020 STM-1&4 optical
NPT-1020 100/1000Base-X
DHGE_8 100/1000Base-X
DMCES1_4 STM-1&4 optical
ECI Telecom Ltd. Proprietary
Cable type Mating connector
Multipair cable (2 x 2 x 50-pin SCSI male
21 120 Ω twisted
pairs)
Coaxial cable DIN 1.0/2.3
Multipair cable (2 x 2 x 50-pin SCSI male
21 120 Ω twisted
pairs)
Multipair cable (2 x 36 pin SCSI male
18 100 Ω twisted
pairs)
Fiber type
One pair of fiber patch cords per interface
One pair of fiber patch cords per interface
One pair of fiber patch cords per interface
One pair of fiber patch cords per interface
Connector at other Qty./Module
end
Open
Open (prepared in
the field)
Open
Open
Mating connector Qty./Module
LC male 4 fibers
LC male 8 fibers
LC male 8 fibers
LC male 8 fibers
Before You Start
3
6
2
1
1
1
1
1
1
1
3-11