5.10.2 Test Value Setting; 5.10.3 Test 2 Mode - YOKOGAWA Admag TI Series User Manual

5.10.2 Test Value Setting

It is necessary to set a test value for the terminal output value (pulse/status) and the process
value.
The setting can be configured with the following parameters.
However, the unit of the process value to test is the unit specified in Subsection 5.1.4. If the unit is
changed, the process value is also changed in conjunction with the changed unit.
Menu path
Display
F
OUNDATION
Fieldbus
Block Relative
Name Index
MTB 97
MTB 98
MTB 99

5.10.3 Test 2 Mode

Test 2 Mode is the function to perform a test to the process value, analog output, totalized value
and pulse at once.
The test value can be set in the range between -10.0% and 110.0%.
Input test values (%) are tested with a scale value in response to the span of each process value.
Menu path
Display
F
OUNDATION
Fieldbus
Block Relative
Name Index
MTB 100
MTB 101
From the table below, select the setting for Test 2 mode.
Display
Normal
Test
Device setup ► Diag/Service ► Test ► (see below)
Device Configuration ► MTB ► Device Configuration ► Query Device ► MaintTB Original
Parameters(Part2) ► Page 4 ► Test ► (see below)
Parameter
Display
Velocity Velocity Test Value
PO1 P1 Test Value
SO1 SO1 Test Value
Device setup ► Diag/Service ► Test ► (see below)
Device Configuration ► MTB ► Device Configuration ► Query Device ► MaintTB Original
Parameters(Part2) ► Page 4 ► Test ► (see below)
Parameter
Display
Test 2 mode Test 2 Mode
Test 2 value Test 2 Output Value
Selection
F Fieldbus
OUNDATION
Normal
Test
<5. Functions>
F Fieldbus
OUNDATION
F Fieldbus
OUNDATION
142
Description
Sets the display item to the flow
velocity.
Specifies the frequency of
pulse output or frequency
output 1 for the I/O2 terminal.
Specifies the status of status
output 1 for the I/O2 terminal.
Description
Setting Test 2 mode
Setting Test 2 mode value
IM 01E21A02-03EN