Restore/Duplicate Parameter - YOKOGAWA Admag TI Series User Manual

IMPORTANT
• When backing up the data in the microSD card, make sure that the preparation of the
microSD card is completed. It takes approximately one minute until the product is ready to
store data in the microSD card after it has been turned on.
• Note that parameters cannot be changed while the backup function is running. It takes
approximately 20 seconds to complete backup processing.
• Take care not to duplicate the file name when backing up data to the microSD card.
• Note that if the microSD card runs out of free space, the subsequent data will not be stored.
NOTE
The backup name and date do not affect the backup function. Use this as the memo column
when performing the backup function.
5.11.2

Restore/Duplicate Parameter

If the restore function is used, it becomes possible to restore parameter settings, which are
backed up in the display's built-in memory or microSD card (with the optional code MC selected),
to the product. Also, it is possible to return parameters to default values defined when shipped
from the factory and to duplicate the backed-up parameters to other device based on the same
specifications.
NOTE
When using the restore function, set STB, DTB, MTB, and LTB to the O/S mode.
IMPORTANT
For the remote type, it is necessary to set the device information of the remote sensor to the
parameters of the remote transmitter.
The methods to restore or duplicate settings can be selected from the following four types.
Duplicate Data
Restore Data
Compulsion Data
Restore Factory
When using the restore function, always make sure that the backed-up device information
matches the device information to be restored.
The table below shows the consistency of the device information.
Device Information
Option Board ID
Transmitter Serial No
Restores the target parameter (excluding the service parameters related to the
transmitter adjustment) from the product in which the parameter is backed up.
Restore is also executable for other products.
Restores the target parameter (including the service parameters related to the transmitter
adjustment) from the product in which the parameter is backed up.
Restore is not executable for other products.
Restores the target parameter (specified at shipment from the manufacturing factory)
from the product for which the parameter is backed up.
Forced restore is also executable for other products.
Restores all the target parameters (parameters related to items specified at shipment
from the manufacturing factory).
Duplicate Data
<5. Functions>
: Match between devices is required
Restore Data
 
-

149
Compulsion Data
-
-
IM 01E21A02-03EN