Definition Of Combining Function Blocks - YOKOGAWA Admag TI Series User Manual

4.3 Definition of Combining Function Blocks
The input/output parameters for function blocks are combined. Specifically, see "VFD Parameter
Configuration" in Section 4.6 for the details though the setting is written to the link object of this
product. It is also possible to read values from the host at proper intervals instead of connecting
the block output of this product to other blocks.
The combined blocks need to be executed synchronously with other blocks on the
communications schedule. In this case, change the schedule of this product as shown in Table
4.3.
Table 4.3 Execution Schedule of the Function Blocks
Index
MACROCYCLE_
269(SM)
DURATION
351(SM) FB_START_ENTRY.1
FB_START_ENTRY.2 to
352~381(SM)
FB_START_ENTRY.31
The maximum of 10 ms is taken to execute the AI block. For scheduling of communications for
combination with the next function block, arrange the schedule so that the execution starts after
a lapse of longer than this time. Do not make settings so that function blocks of this product are
executed at the same time (execution time is overlapped).
Figure 4.3 shows the execution schedule example of the function block like the loop shown in
Figure 4.2.
EJX
LI100
AXG
#1
Figure 4.2 Example of Loop Connecting Function Block of This Product with Other Devices
LI100
OUT
BKCAL_IN
FI100
Commu-
nication
Schedule
Figure 4.3 Function Block Schedule and Communication Schedule
Parameter Name
LIC100
FIC100
FI100
FC100
Macrocycle (Control Period)
IN
CAS_IN
LIC100
BKCAL_OUT
FIC100
IN
BKCAL_IN BKCAL_OUT
OUT
Unscheduled
Communication
Scheduled
Communication
<4. Configuration>
Setting (Enclosed is factory-setting)
Cycle (MACROCYCLE) period of control or measurement. Unit is
1/32 ms. (32000 = 1s)
Function block startup time. Offset time from the start of
MACROCYCLE specified in 1/32 ms. (0 = 0 s)
No settings
F0402.ai
FC100
F0403.EPS
24
IM 01E21A02-03EN