Connection Of Contact Point Output To Di Function - YOKOGAWA Admag TI Series User Manual

5.3.2

Connection of Contact Point Output to DI Function

The contact point outputs at STB and DTB are output to specific channels, respectively. By
selecting the channel to use in the DI function block, it is connected to the contact point.
The relation of the channel for each contact point output and the channel which can be selected
from each DI function block is shown in the figure below.
STB
Velocity1 Hi/Lo Limit
Velocity2 Hi/Lo Limit
Volume1 Hi/Lo Limit
Volume2 Hi/Lo Limit
Mass1 Hi/Lo Limit
Mass2 Hi/Lo Limit
Calorie1 Hi/Lo Limit *
Calorie2 Hi/Lo Limit *
DTB
Adhesion1 Hi/Lo Limit
Adhesion2 Hi/Lo Limit
ElectrodeA1 Hi/Lo Limit
ElectrodeA2 Hi/Lo Limit
ElectrodeB1 Hi/Lo Limit
ElectrodeB2 Hi/Lo Limit
Flow Noise1 Hi/Lo Limit *
Flow Noise2 Hi/Lo Limit *
Conductivity1 Hi/Lo Limit *
Conductivity2 Hi/Lo Limit *
Adhesion Warning Status
Adhesion Alarm Status
Flow Noise Warning Status *
Flow Noise Alarm Status *
Low Conductivity Warning Status *
Figure 5.3.2 Relation of Process Value of STB and DTB and DI Function Block
The information of the figure above can be organized below.
Table 5.3.1 List of Relation of Contact Point Output and DI Function Block
CHANNEL
number
21 Velocity1 Hi/Lo Limit
22 Velocity2 Hi/Lo Limit
23 Volume1 Hi/Lo Limit
24 Volume2 Hi/Lo Limit
Channel 21
Channel 22
Channel 23
Channel 24
Channel 25
Channel 26
Channel 27
Channel 28
Channel 29
Channel 30
Channel 31
Channel 32
Channel 33
Channel 34
Channel 35
Channel 36
Channel 37
Channel 38
Channel 39
Channel 40
Channel 41
Channel 42
Channel 43
Channel Selection
Display F
Velo.1
Velo.2
VolFlw.1
VolFlw.2
<5. Functions>
DI1
DI2
DI3
* for AXG
F0446.ai
Fieldbus
OUNDATION
Model
AXG / AXW
AXG / AXW
AXG / AXW
AXG / AXW
IM 01E21A02-03EN
79