For Safe Use Of Product - YOKOGAWA Admag TI Series User Manual

1.1

For Safe Use of Product

For the protection and safe use of the product and the system in which this product is
incorporated, be sure to follow the instructions and precautions on safety that are stated in user's
manual whenever you handle the product. Take special note that if you handle the product in a
manner that violates these instructions, the protection function of the product may be damaged
or impaired. In such a case, YOKOGAWA shall not be liable for any indirect or consequential loss
incurred by either using or not being able to use the product.
General
„ „
WARNING
• Do not open the cover in wet weather or humid environment. When the cover is open, the
stated enclosure protection is not applicable.
• When opening the cover, wait for more than 20 minutes after turning off the power. Only an
expert engineer or skilled personnel is permitted to open the cover.
Operation
„ „
WARNING
Be sure to enable the write protection function to prevent parameters from being overwritten after
finishing parameter setting.
In rare cases, the IR switches may respond unexpectedly to water drops or extraneous
substances sticking on the surface of the display panel due to characteristics of the operating
principles. The possibility of malfunction arises after rain or cleaning near the place where the
flowmeter is installed. Repeatedly turning a flashlight, etc. on and off in the direction of the IR
switch may also be a cause of malfunction.
Read the installation manual for the hardware write lock function, and Section 5.12 for the
software write lock function.
<1. Introduction>
IM 01E21A02-03EN
10