YOKOGAWA Admag TI Series User Manual page 172

Relative
Index Parameter Name
Index
26 1026 SHED_RCAS
27 1027 SHED_ROUT
28 1028 FAULT_STATE
29 1029 SET_FSTATE
30 1030 CLR_FSTATE
31 1031 MAX_NOTIFY
32 1032 LIM_NOTIFY
33 1033 CONFIRM_TIME 640000
34 1034 WRITE_LOCK
35 1035 UPDATE_EVT
36 1036 BLOCK_ALM
37 1037 ALARM_SUM
38 1038 ACK_OPTION
39 1039 WRITE_PRI
40 1040 WRITE_ALM
Write
Default Value
Mode
640000 AUTO
640000 AUTO
1 -
1 AUTO
1 AUTO
128 -
128 AUTO
AUTO
1 AUTO
0(Uninitialized) AUTO
0(Uninitialized) -
0,0 -
0 -
0 -
0(Uninitialized) AUTO
0(Uninitialized) -
0,0 -
0(Other) -
0 -
0x0000 -
0x0000 -
0x0000 -
0x0000 AUTO
0xFFFF AUTO
0 AUTO
0(Uninitialized) AUTO
0(Uninitialized) -
0,0 -
0(Other) -
0(State 0) -
<6. Parameter Lists>
Description
Sets time for device's communication
timeout set for Remote cascade. Used
only with PID function.
Sets time for device's communication
timeout set for remote out. Used only
with PID function.
Indicates failsafe state. Not used for this
product.
Starts failsafe state. Not used for this
product.
Resets failsafe state. Not used for this
product.
Maximum number of alert information
which can be held in the device.
Maximum number of alert information
which the device notifies at a time. By
specifying this, the number of alert
to notify the host is limited, and it can
prevent the host from overflowing.
Prohibits setpoints from being written
from the outside.
1: Not Locked
2: Locked
Indicates contents of the event when an
update event (a change to the setpoint)
occurs.
Indicates contents of the alarm when a
block alarm occurs.
Parameter to show the alarm status
of the entire block. Bit assignment
complies with the Communication
standard specifications.
Sets operation to acknowledge
(acknowledgment for the alarm) of
various alarms. By setting a bit to the
alarm, the device operates for the
alarm as if it is acknowledged without
the acknowledgment. Bit assignment
complies with the Communication
standard specifications.
Sets the WRITE_ALM priority. It can be
used not just to set the priority, but to
disable alarm notification with settings.
To activate an alarm on communication,
it is necessary to specify the priority for
alarm activation in advance. To activate
an alarm, set 3 or more. By sending with
priority information being added in a
communication frame when the alarm is
activated, for example, the alarm is used
to apply a filter to ignore values below
the specified priority on the host side.
The alarm is activated if the write lock
condition is changed in the sequence
like, "Lock -> Reset" or "Reset -> Lock".
171
IM 01E21A02-03EN