YOKOGAWA Admag TI Series User Manual page 118

(1) Trend graph display setting
The process value and high/low limit that can be shown in the trend graph are as follows:
Process value
Flow rate (%) FLP
PV PRV
Flow velocity VEL
Volumetric flow rate VFL
Mass flow rate MFL
*
Calorie CAL
Totalizer 1 TL1
Totalizer 2 TL2
*Only available for AXG, not for AXW.
The setting can be configured with the following parameter.
Menu path
Display Device setup ► Detailed setup ► Display set ► Optional config ► (see below)
F Device Configuration ► LTB ► Device Configuration ► Configuration ► Display Operation
OUNDATION
Fieldbus Configuration ► (see below)
Block Relative
Name Index
LTB 35 Display mode
From the table below, select the trend graph display.
Selection
F
OUNDATION
Display
Fieldbus
Normal Normal
Trend Trend
(2) Trend graph display item setting
The setting can be configured with the following parameters.
Menu path
Display Device setup ► Detailed setup ► Display set ► Trend select ► (see below)
F Device Configuration ► LTB ► Device Configuration ► Configuration ► Trend Select ►
OUNDATION
Fieldbus (see below)
Block Relative
Name Index
Display
LTB 38 Trend 1
LTB 39 Trend 2
LTB 40 Trend 3
LTB 41 Trend 4
Display Low limit
0%
0
Preset value specified in
Subsection 5.2.7
Parameter
Display F
OUNDATION
Display Measure Mode
Does not display a trend graph (normal display).
Displays a trend graph.
Parameter
F Fieldbus
OUNDATION
Display Trend Select 1
Display Trend Select 2
Display Trend Select 3
Display Trend Select 4
<5. Functions>
High limit
100%
Span value specified in
Subsection 5.1.5
Target value of the totalizer
specified in Subsection 5.2.3
Description
Fieldbus
Specifies the display of a trend
graph.
Description
Description
Specifies item 1 to be shown in a trend
graph.
Specifies item 2 to be shown in a trend
graph.
Specifies item 3 to be shown in a trend
graph.
Specifies item 4 to be shown in a trend
graph.
117
IM 01E21A02-03EN