Diagnosing Low Conductivity (Only Available For Axg, Not For Axw) - YOKOGAWA Admag TI Series User Manual

Selection
Display
Disable
Enable
NOTE
If the flow noise diagnosis function is set to "Disable", the flow noise value and level are cleared.
5.9.9 Diagnosing Low Conductivity (only available for AXG,
not for AXW)
The low conductivity diagnosis function calculates conductivity from the resistance value and size
of the electrode and displays a warning if the conductivity falls below the specified value.
For details about the alarm and warning, refer to Subsection 5.6.1. Also, for the conductivity
value, refer to Subsection 5.1.3.
The setting can be configured with the following parameters.
Menu path
Display
F
OUNDATION
Fieldbus
Block Relative
Name Index
DTB 38
DTB 39
Menu path
Display
F
OUNDATION
Fieldbus
Block Relative
Name Index
MTB 48
*1: From the table below, select the use of the low conductivity diagnosis function.
Selection
Display
Disable
Enable
F
OUNDATION
Fieldbus
Disable Does not use the flow noise diagnosis function.
Enable Uses the flow noise diagnosis function.
Device setup ► Diag/Service ► Diagnosis ► Conductivity ► (see below)
Diagnostic ► DTB ► Device Diagnostics ► Diagnostics/Alerts ► Diagnostics ►
Conductivity ► (see below)
Parameter
Display
Function Low Conduct Check
Low limit Conductivity Limit
Device setup ► Detailed setup ► Device info ► Order info ► (see below)
Device Configuration ► MTB ► Device Configuration ► Device Information ► (see below)
Parameter
Display
Electrode size
F
OUNDATION
Fieldbus
Disable Does not use the low conductivity diagnosis function.
Enable Uses the low conductivity diagnosis function.
Description
F Fieldbus
OUNDATION
F Fieldbus
OUNDATION
Electrode Size
Description
<5. Functions>
Description
Specifies the use of the
low conductivity diagnosis
*1
function.
Specifies the value used to
judge the low conductivity.
Description
Displays the electrode size.
IM 01E21A02-03EN
138