Alarm Display Setting - YOKOGAWA Admag TI Series User Manual

5.6.4

Alarm Display Setting

(1) Alarm display
If an error occurs on this product, an alarm appears on the display. The alarm display modes
are classified into two types: one mode to display a process value and alarm name, and another
mode to display an alarm name and action.
If multiple alarms occur on this product, they will be displayed in sequence on the display.
The setting can be configured with the following parameter.
Display
F
OUNDATION
Fieldbus
Block Relative
Name Index
LTB 30
From the table below, select the alarm display.
Selection
Display
Normal
Detail
(2) Alarm display based on NAMUR NE107
A prefix can be assigned to the alarm name based on NAMUR NE107.
The setting can be configured with the following parameter.
Menu path
Display
F
OUNDATION
Fieldbus
Block Relative
Name Index
LTB 29
Device setup ► Detailed setup ► Display set ► Optional config
Device Configuration ► LTB ► Device Configuration ► Configuration ► Display Operation
Configuration ► (see below)
Parameter
Display
Alarm display Display Alarm
F
OUNDATION
Fieldbus
Normal Displays the process value and alarm name.
0.00000 m/s
018: Coil open
SET
Detail Displays the alarm name and action.
System Alarm
018: Coil open
Cut the power and
check coil & EX cable.
SET
Device setup ► Detailed setup ► Display set ► Optional config ► (see below)
Device Configuration ► LTB ► Device Configuration ► Configuration ► Display Operation
Configuration ► (see below)
Parameter
Display
NE107 display Display NE107
<5. Functions>
F Fieldbus
OUNDATION
Description
01 : 00
VEL
0.0 %
FLP
4.000 mA
AO1
SFT INC
F0425.ai
01 : 00
SFT INC
F0426.ai
F Fieldbus
OUNDATION
105
Description
Specifies the alarm display.
Description
Sets the alarm display based
on NAMUR NE107.
IM 01E21A02-03EN