YOKOGAWA Admag TI Series User Manual page 79

Display --
F
Device Configuration ► DTB ► Device Configuration ► Configuration ► Limit Switch
OUNDATION
Fieldbus Conductivity 2 ► (see below)
Block Relative
Name Index
Display
--
DTB 103
--
DTB 104 --
DTB 105 --
DTB 106 --
DTB 107 --
The following selections are available as an operation method.
Selection
F
OUNDATION
Display
Fieldbus
-- state 0
-- state 1
The following selections are available as an operation direction.
Selection
F
OUNDATION
Display
Fieldbus
-- Low limit
-- High limit
Parameter
F Fieldbus
OUNDATION
Lim.Sw. Conductivity 2 Value
► Lmt Sts Cndc2.Status
Lim.Sw. Conductivity 2 Value
► Lmt Sts Cndc2.Value
Lmt Sts Cndc2 Sp
Lmt Sts Cndc2 Act Dir
Lmt Sts Cndc2 Hys
Lmt Sts Cndc2 Unit
Limit status is not activated (conditions are not met)
Limit status is activated (conditions are met)
Does not use the reset/preset function of the totalized value.
Uses the reset function of the totalized value.
<5. Functions>
Description
Displays the status of the contact point
output of conductivity limit switch 2.
Displays the contact point output of
conductivity limit switch 2.
Specifies the threshold of conductivity
limit switch 2.
Specifies the operation direction of
conductivity limit switch 2.
Specifies the hysteresis of conductivity
limit switch 2.
Displays the unit of the conductivity.
Description
Description
78
IM 01E21A02-03EN