YOKOGAWA Admag TI Series User Manual page 122

(5) Display squawk setting (squawk)
The back light of the display can be blinked (squawked) at 4-second intervals to identify a
communicating product if a number of the same instrument is installed.
The setting can be configured with the following parameter.
Menu path
Display Device setup ► Diag/Service ► Disp indicator ► (see below)
F Device Configuration ► LTB ► Device Configuration ► Configuration ► Display Indication
OUNDATION
Fieldbus ► (see below)
Block Relative
Name Index
LTB 44 Squawk
From the table below, select whether or not to blink the display. In the communication access of F
communication access is set with the procedure of the interactive operation guide called DD Method.
Selection
F
OUNDATION
Display
Fieldbus
Off Off
On On
Squawk once Squawk once
(6) Low-cut value setting
The low-cut value can be set for the PV value displayed on the display.
The setting can be configured with the following parameter.
Menu path
Display Device setup ► Detailed setup ► Display set ► Optional config ► (see below)
F
Device Configuration ► LTB ► Device Configuration ► Configuration ► Display Operation
OUNDATION
Fieldbus Configuration ► (see below)
Block Relative
Name Index
LTB 47 Low cut
NOTE
If the output process value to be output is changed, it is necessary to specify the low-cut value
again.
(7) All block target mode
When setting a parameter, it is necessary to set a parameter by setting appropriate MODE_BLK.
Target of RB/STB/DTB/LTB/MTB/FB (AIFB,DIFB) to O/S for each parameter. The parameter to
simplify it on the display is "All block target mode". This parameter makes it possible to set RB/
STB/DTB/LTB/MTB/FB (AIFB, DIFB) to O/S at a time and to reset them to the original mode. Use
this parameter to set a parameter in the following procedures.
1. Set "All block target mode" to O/S.
2. Set the required parameter from the display.
3. Set "All block target mode" to "Restore".
Parameter
Display F
OUNDATION
Squawk
Does not blink the display.
Blinks the display (continuously).
Blinks the display (only once).
Parameter
Display F
OUNDATION
Display Low Cut
<5. Functions>
Description
Fieldbus
Specifies the blinking operation
of the display.
OUNDATION
Description
Description
Fieldbus
Specifies the low-cut value to
the PV value shown on the
display.
121
Fieldbus, the
IM 01E21A02-03EN