Operation By Display Unit; Display And Basic Configuration; Display Mode And Setting Mode - YOKOGAWA ADMAG TI Series User Manual

5. Basic Operating Procedures
5.1

Operation by Display unit

(Please read the descriptions on IM 01E22A01-01EN.)
5.2 Display and Basic Configuration
(Please read the descriptions on IM 01E22A01-01EN.)
5.3

Display Mode and Setting Mode

The device runs in the Display Mode when the power is turned on. For check or change of parameters, the Setting Mode
must be activated. The following procedure explains how to change to the Setting Mode. For the function of IR switches,
read Subsection 5.2.1.
[Procedure]
1) Keep touching [SET] switch for few seconds.
00 : 00
PRV
0.00000
l/min
0.00000m/s
VEL
FLB
SET SFT INC
F0501.ai
2) Touch [SFT] + [INC] switches.
00 : 00
Touch SFT + INC
SET SFT INC
F0502.ai
3) "No" is selected.
Touch [INC] switch and select "Yes".
00 : 00
Setting Mode
No
▲
Yes
▼
SET SFT INC
F0503.ai
4) Touch [SET] switch.
00 : 00
Setting Mode
Yes
▲
No
▼
SET SFT INC
F0504.ai
5) "Yes" is blinking.
Touch [SET] switch again.
00 : 00
Setting Mode
Yes
SET SFT INC
F0505.ai
6) The screen moves to the menu of Operation Level.
00 : 00
Operation level
Specialist
▲
Exit
Operator
▼
SET SFT INC
F0506.ai
<5. Basic Operating Procedures>
7) Select an appropreate operation level by moving the
cursor with [INC] or [DEC] switch.
Passcode is not necessary for "Operator". For
"Maintenance" and "Specialist", passcode is
necessary for each. For passcode setting, [SFT] is for
position change, and [INC] is for number, then twice [SET]
is for entry completion.
The default passcode at the factory shipment is set to
"0000".
00 : 00
Pass code
****
0000
0000 9999
SET SFT INC
F0507.ai
8) When the Operation Level is determined, the screen
moves to "Device setup" as the Setting Mode where
parameters can be configured.
9) After completing parameter setting, push [ESC]
switch. The screen returns to the Display Mode.
9
IM 01E21A01-03EN-A