Profibus Dp Interface (Simotion D410 Dp Only) - Siemens SIMOTION D410 PN Manual

Further information
For information on the components that can be connected via DRIVE-CLiQ (setup,
connection, configuration, etc.) see
●
●
●
●
●
●
●
3.4

PROFIBUS DP interface (SIMOTION D410 DP only)

SIMOTION D410 DP provides one interface to connect to PROFIBUS DP. The interface can
be run asynchronously or isochronously, equidistant.
A baud rate of up to 12 Mbps can be set for the PROFIBUS DP interface.
SIMOTION D410 includes master and I-slave functionality.
Note
If a SIMOTION D410 DP is operated as a passive PROFIBUS I-slave, the display,
measuring functions, and controller optimization engineering functions will be very slow. If
possible, use the "active I-slave" setting for local commissioning (which does mean that an
equidistance is no longer possible) and for complete commissioning, switch to "passive I-
slave".
Interface features
Table 3- 8
Features
Connector type
Cable type
Maximum cable length
Maximum data rate
SIMOTION D410
Manual, 02/2012
SINAMICS S120 Control Units and Additional System Components
SINAMICS S120 for AC Drives
SINAMICS S120
Commissioning Manual
SINAMICS S120 Booksize Power Units
SINAMICS S120 Safety Integrated
TM15/TM17 High Feature SIMOTION Terminal Modules
SIMOTION Terminal Modules TM15 / TM17
Interface X21
3.4 PROFIBUS DP interface (SIMOTION D410 DP only)
Manual
Manual
Function Manual
Manual
Type
9-pin SUB-D socket
PROFIBUS cable
100 m at 12 Mbps
12 Mbps
Manual
Commissioning Manual
Interfaces
41