Locking The Cutting-Unit Pivot For Cutting Grass On A Hill Side; Installing The Cutting Unit Lift-Arm Chains; Installing The Reel Motors - Toro Reelmaster 5510 Operator's Manual

Locking the Cutting-Unit Pivot for Cutting Grass on a Hill
Side
Lock the cutting-unit pivots with snapper pins
prevent the cutting units from rotating downhill
when cutting across the face of a hill.
Note:
the cutting unit.
Note:
unit.

Installing the Cutting Unit Lift-Arm Chains

Secure the lift-arm chain
with the snapper pin
Note:
in the cutting unit Operator's Manual.

Installing the Reel Motors

1. Grease the reel-motor spline shaft.
2. Oil the reel motor O-ring and install it onto the motor flange.
3. Install the motor
3464-490A
Use the hole in the pivot yoke to lock
Use the slot for a steering cutting
to the chain bracket
.
Use the number of chain links described
by rotating it clockwise so that the motor flanges clear the bolts
to
G437965
G402673
Page 3–10 Setup: Installing the Cutting Units
.