Setup; Preparing The Machine; Installing The Cutting Unit To The Traction Unit - Toro Groundsmaster e3200 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
WARNING
If you leave the key in the switch, someone could accidentally start the machine and seriously
injure you or other bystanders.
Remove the key from the switch before you install the cutting unit.
Note:
Determine the left and right sides of the
machine from the normal operating position.
1

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface.
2. Use the display to turn off the weight transfer
setting; refer to your traction unit Operator's
Manual.
3. Move the lift arms to the lowest position.
4. Shut off the machine and remove the key.
Description
No parts required
Hex-head bolt
Washer
Height-of-cut pin
No parts required
No parts required
Qty.
–
Prepare the machine.
2
2 Install the cutting unit to the traction unit.
2
–
Level the cutting unit.
–
Grease the cutting unit.
2
Installing the Cutting Unit
to the Traction Unit
Parts needed for this procedure:
2 Hex-head bolt
2 Washer
2 Height-of-cut pin
Procedure
1. Position the cutting unit in front of the traction
unit.
2. Push a lift arm down until the holes in the lift arm
line up with the holes in the castor arms, then
insert a washer and bolt through both arms.
3. Align the lift-arm holes with the castor-arm holes.
4. Use 2 hex-head bolts and 2 washers to secure
the castor arms to the lift arms
Ensure that the washers are positioned with the
curved side adjacent to the bolt head
If you have previously used the bolts to
install the cutting unit: Apply thread-locking
compound to the threads of the bolts.
8
Use
(Figure 3).
(Figure 3).