Cutting Unit Drive Lever Assembly - Toro Greensmaster eFlex 1021 Service Manual

Cutting Unit Drive Lever Assembly

g336962
1. V-ring seal
2. Reel lever handle rod
3. Knob
4. Retaining ring
5. Control shaft clamp (2 each)
6. Socket head screw (4 each)
7. Extension spring (2 each)
8. Control cover
9. Bolt and washer assembly (8 each) 18.
Disassembling the Cutting Unit Drive Lever Assembly
Greensmaster ® eFlex 1021
20248SL Rev A
10. Lower handle cover
11. Reel cable
12. Split bushing
13. Cotter pin clip
14. Link assembly
15. Main control shaft
16. Split bushing
17. Socket cap
Cotter pin clip
Note: Refer to Figure 82
1. Park the machine on a level surface. Ensure that the key switch is in OFF
position and the traction control is in NEUTRAL.
2. Disconnect the battery pack; refer to
(page 5–3).
Figure 82
19.
20.
21.
22.
23.
24.
25.
26.
27.
during this procedure.
Connecting the Lithium Battery Pack
Page 6–9 Controls, Wheels and Accessories : Service and Repairs
Clevis connector
Clevis pin (4 each)
Extension spring
Shoulder screw
Reel lock lever assembly
Bail latch spacer
Upper receiver weldment
Flange nut
Reel lever assembly