Jam At Front Cover Open Front Cover And Remove Paper - Xerox Phaser 6128MFP Service Manual

Jam at Front Cover Open Front Cover and Remove Paper

Phaser 6128MFP Service Manual
The Registration Sensor is not turned On within the specified time. The following
troubleshooting procedure applies to these errors.
Applicable Error
• Jam at Front Cover Open Front Cover and Remove Paper
Initial Actions
• Check the media path for obstructions or debris.
• Check the condition of the Registration Rollers.
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Registration In Actuator, PL3.2.11
Registration Sensor, PL3.2.13
Left Side Harness, PL10.4.18
MCU Board, PL10.7.7
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the media condition.
Is the media damaged or damp?
2 Check the Registration Rollers.
Are the rollers touching and free of
debris?
3 Run the Registration Clutch test
(DO-00 and DO-29) (page 4-48).
Does the Registration Clutch and
Registration Rollers operate?
4 Run the Registration Sensor test (DI-
02) (page 4-35).
Use the Registration Actuator In to
toggle the sensor output.
Does the sensor operate?
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 2 - Feed and Laser Unit" on page 10-7
"Media Feed" on page 10-15
"Main Drive" on page 10-16
Yes
Replace the
media.
Go to step 3.
Go to step 4.
Replace the
MCU Board
(page 8-57).
No
Go to step 2.
Repair or
replace the
rollers.
Go to step 10.
Go to step 5.
3-43