Installing The Optional Acquity Upc Flow-Splitter Kits; Dual-Detection Flow-Splitter Kit - Waters ACQUITY Isocratic Solvent Manager Overview And Maintenance Manual

To change the split ratio:
1. Disconnect the inlet 1, outlet 1, inlet 2, and outlet 2 tubing from the
restrictor module.
Inlet 1:
From
column
2. Connect the inlet 1, outlet 1, inlet 2, and outlet 2 tubing to the desired
restrictor module.
To prevent contamination, install fluoropolymer plugs on any
Tip:
unused restrictor modules.
Installing the optional ACQUITY UPC
Install the optional ACQUITY UPC
QDa Detector in an ACQUITY UPC
To ensure compliance with Japan's High Pressure Gas Safety Act,
Note:
stainless steel versions of the ACQUITY UPC
available.
Installing the optional ACQUITY UPC
Flow-splitter kit
Required materials
• Gloves: clean, powder-free, chemical-resistant
• ACQUITY UPC
Installing the optional ACQUITY UPC
Restrictor module (3)
Outlet 1: Inlet 2:
From ISM
To optical
outlet
detector
2
Flow-splitter kit to use an ACQUITY
2
system.
2

Dual-Detection Flow-splitter kit

September 26, 2013, 715004208 Rev. A
Outlet 2:
To QDa
detector source
2
Flow-splitter kits
2
Flow Splitter kits are
2
Dual-Detection
2
Flow-splitter kits
49