Priming A Dry Ism Using A Syringe - Waters ACQUITY Isocratic Solvent Manager Overview And Maintenance Manual

2 Preparing for Operation
6. In the Time box, specify the number of minutes from 0.1 through 60.0.
Default:
Requirement:
until a steady flow exits the vent tubing (typically requires 7 to 10
minutes).
7. Click Start.
Result:
path is primed.

Priming a dry ISM using a syringe

Warning:
when you handle solvents, change tubing, or operate the ISM. Consult
the Material Safety Data Sheets regarding the solvents you use.
Caution:
powder-free gloves when priming a dry ISM using a syringe.
Required materials
• Gloves: clean, powder-free, chemical-resistant
• 30-mL syringe (startup kit)
• Short length of Pharmed
• Tubing adapter (startup kit)
To prime a dry ISM:
1. Open the device's front door.
68 September 26, 2013, 715004208 Rev. A
2.0 minutes
All solvent tubing must contain solvent. Prime the ISM
When solvent flows out the vent tubing without bubbles, the
To prevent injury, always observe Good Laboratory Practices
To prevent contamination, wear clean, chemical-resistant,
®
tubing (startup kit)