Table of Contents
Advertisement
3 Maintenance Procedures
Replacing the seal wash solvent filter
Warning:
when you handle solvents, change tubing, or operate the ISM. Consult
the Material Safety Data Sheets regarding the solvents you use.
Caution:
handling the solvent filter. Oil from your hands can contaminate the
seal wash solvent filter.
Required materials
•
Gloves: clean, powder-free, chemical-resistant
•
New seal wash solvent filter
To replace a seal wash solvent filter:
1.
Remove the filter end of the solvent tubing from the solvent bottle.
2.
Remove the old seal wash solvent filter from the short piece of PTFE
tubing.
3.
Insert the new seal wash solvent filter into the PTFE tubing, pushing
until it contacts the solvent tubing.
4.
Insert the filter end of the solvent tubing into the solvent bottle.
5.
Shake the filter, to remove any air from it.
6.
Prime the ISM (see
80
September 26, 2013, 715004208 Rev. A
To prevent injury, always observe Good Laboratory Practices
Wear clean, chemical-resistant, powder-free gloves when
Solvent tubing
page
67).
Solvent filter
PTFE tubing
Hide quick links:
Advertisement
Table of Contents
