Monitoring Leds; Power Led; Status Led - Waters ACQUITY Isocratic Solvent Manager Overview And Maintenance Manual

2 Preparing for Operation
9. In the Time box, specify the number of minutes, from 0.1 through 60.0.
Recommendation:
prime the isocratic solvent manager until a steady flow exits the vent
tubing (typically 3 minutes).
10. Click Start.
11. Slowly withdraw the syringe plunger.
12. When solvent flows out the vent tubing without bubbles, remove the
syringe from the vent tubing and reconnect the vent tubing to the drip
tray.
Requirements:
• Ensure that the solvent reservoir contains enough solvent for future
methods.
• All solvent tubing must contain solvent.

Monitoring LEDs

Light emitting diodes on the ISM indicate its state of functioning.

Power LED

The power LED, on the left-hand side of the ISM's front panel, indicates when
the ISM is powered-on or powered-off.
Power LED indications:
LED mode and color
Green
Black (unlit)

Status LED

The flow LED, on the right-hand side of the power LED on the ISM's front
panel, indicates the flow status.
70 September 26, 2013, 715004208 Rev. A
The default setting is 2.0 minutes. Nevertheless,
Description
Power is applied to the ISM.
Power is not applied to the ISM.