At$Etsav# Event Timer Save Configuration - Novatel MT 3050 At Command Reference

AT$ETSAV# Event Timer Save Configuration

AT$ETSAV#
Command Function
Syntax Query
Syntax
Write Syntax
Write Response
Read Syntax
Read Response
Execute Syntax
Execute Response
Unsolicited Response
Parameter Values
<flag>
Notes
Example
Event Timer Save Configuration
These commands allow the user to set/query a flag that is used to determine
whether the event timer value will be persistent through a reset. If the flag is set
for the timer, the timer count will be saved roughly once a minute and the saved
value will be used as the starting value for the timer following a reset. This is
intended to support long-range timers (for example, 3 hours) where resolution
of +/-1 minute would be acceptable.
If the flag is clear, the timer always starts at zero following an reset.
The # sign represents timers 1 through 10 (i.e. ETSAV1).
AT$ETSAV#=?
$ETSAV#:(0-1)
OK
AT$ETSAV#=<flag>
OK
AT$ETSAV#?
$ETSAV#: <flag>
N/A
N/A
N/A
1 =save this event timer value roughly once a minute to flash
0 = restart this event timer at zero following reset (default)
AT&W must be issued after flag is set to ensure flag retains its status through a
reset.
N/A
- 231 -