Chanconfig; Configuration Values - Novatel EuroPak-15a User Manual

Commands
5.3.3

CHANCONFIG

This command changes the channel configuration of the receiver. This will effect the number of channels
tracking GPS signals and the number of channels tracking GEO signals. Entering this command will reset the
receiver, causing the receiver to initiate a cold-start bootup and reset all data stored in NVM to factory default
values (except for the channel configuration).
The default configuration of the L1L5GPS(T) model is 16GPSL1L5 while for the L1E5AGAL(T) model it is
10GALILEO6GPS. If you have a L1E5AGAL(T) model you will also be able to track Galileo and GPS
satellites. If you have an L1L5GPS(T) model you will be able to track GPS but not Galileo satellites.
Syntax:
CHANCONFIG
Field
Field
Name
1 header
2 config
Example:
CHANCONFIG 16GPSL1L5
16GPSL1L5
10GALILEO6GPS
10GALILEODATA6GPS
16GALILEOL1E5a
8GPS8GEO
12GPS4GEOL1L5
16GPSL5
a.
EuroPak-15a Receiver User Manual Rev 5
CONFIG
Valid Values
This field contains the Abbreviated ASCII command name. See
Section 4.1 on Page 31.
See Table 19 below.
Table 19: Configuration Values
ASCII
8 GPS L1 + 8 GPS L5 channels
5 Galileo L1 + 5 Galileo E5a + 6 GPS L1 channels
a
5 Galileo Data L1 + 5 Galileo Data E5a + 6 GPS L1 channels
8 Galileo L1 + 8 Galileo E5a channels
8 GPS L1 + 4 GEO L1 + 4 GEO L5 channels
6 GPS L1 + 6 GPS L5 + 2 GEO L1 + 2 GEO L5 channels
16 GPS L5 channels
Use the 10GALILEODATA6GPS configuration when tracking the GIOVE-A
satellite. GIOVE-A uses a different signal structure than the Galileo SIS-ICD,
therefore the receiver tracks the data signal.
Description
Specifies the channel
configuration for the receiver
to use.
Description
Chapter 5
Message ID: 501
Binary Binary
Format
Bytes Offset
H 0
Enum 4 H
49