At$Pwrsav Enable Power Save Mode - Novatel MT 3050 At Command Reference

AT$PWRSAV Enable Power Save Mode

AT$PWRSAV
Command Function
Syntax Query
Syntax
Write Syntax
Write Response
Read Syntax
Read Response
Execute Syntax Execute
Response
Unsolicited Response
Parameter Values
<ign>
<timeout>
<reg>
Notes
Enable Power Save Mode
This command allows a user to put the device in low power mode at the
<timeout> interval after the Ignition line drops. The ignition line has to be
connected per the user manual for this feature to work properly. A user has the
capability of getting a notification when the device entering low power mode or
returns to normal operating mode.
AT$PWRSAV=?
$PWRSAV: (0-1),(0-65535),(0-1)
OK
AT$PWRSAV=<ign>,<timeout>,<reg>
OK
AT$PWRSAV?
$PWRSAV: 0,0,0
OK
N/A
N/A
0 – disable the Ignition feature
1 – enter low power mode after Ignition signal went low and timeout has expired
0 – 65535 seconds. Timeout value after which the unit will enter low power
mode. Unit will work in normal mode until the timeout has expired.
0 – remain registered with network during low power mode
1 – reset modem when entering normal power mode
An AT$EVENT command has to be set to send a GPS message to the remote host
when entering or exiting power save mode.
The modem Ignition (switched power) Input must be connected to the vehicles
ignition line for this function to work.
- 331 -