Table of Contents
Advertisement
AT$GPSOSI Set And Query GPS Overspeed
Interval
AT$GPSOSI
Command Function
Syntax Query
Syntax
Write Syntax
Write Response
Read Syntax
Read Response
Execute Syntax
Execute Response
Unsolicited Response
Parameter Values
<speed>
<interval>
<sticky>
<status>
<max_speed>
<duration>
Notes
Set and Query GPS Overspeed Interval
This command allows the user to define the criteria for a GPS overspeed event. A
GPS overspeed event occurs when the minimum speed that is defined by the
<speed> parameter is maintained for a specific duration of time.
AT$GPSOSI=?
$GPSOSI: (0-255),(0-65536),(0-1)
OK
AT$GPSOSI=<speed>,<interval>,<sticky>
OK
AT$GPSOSI?
$GPSOSI: <speed>, <interval>, <status>, <max_speed>, <duration>
OK
AT$GPSOSI
ERROR
N/A
Speed, in knots, must be met and/or exceeded to trigger the GPS overspeed event.
Number of consecutive seconds for which <speed> must be maintained to trigger
the GPS overspeed event.
Optional parameter to make overspeed parameters persistent. If 1, then
speed/interval are written to flash immediately (no AT&W required). Default = 0.
If 1, then <max_speed> and <duration> represent a GPS overspeed interval that is
currently active. If 0, they represent the previous GPS overspeed interval.
The highest speed (in knots) that was attained in the current or previous GPS
overspeed interval.
Number of consecutive seconds that the speed was at or above <speed>.
If <speed> is set to zero, the GPS overspeed event is disabled.
- 317 -
Advertisement
Table of Contents
