Gpio Flash Table - Novatel MT 3050 At Command Reference

GPIO Flash Table

Parm1
Bits 16 – 31 determine the low signal state while bits 0 –
15 determine the high signal state. A value of 0 for bits
16 – 31 indicates the GPIO will remain in low signal
state for the same amount of time as the high signal
state (50% duty cycle). The high or low states are
measured in multiples of ¼ seconds. The toggle count is
set by Parm2
Warning:
Flashing GPIO 3 on the MT 3000 will damage the device.
Parm2
The flashing GPIO event will cause the GPIO output
state to toggle at time 0 to the opposite state prior to
starting the GPIO output flash event processing. This
counts as toggle #1. An even number of toggle count
will force a final state which is the same as the initial
state. An odd number of toggle count will force the final
state to be opposite of the initial GPIO output condition.
0 = toggle forever.
- 360 -