Output Event Table - Novatel MT 3050 At Command Reference

Output Event Table

The below table defines the values for <event category>, <parm1> and <parm2> parameter for output events
defined as Output.
Event
Parm1
Category
0 - 10 N/A
11 0
12 - 14 N/A
15 0
16 - 18 N/A
19 0
20 - 22 0
23 0
24 - 26 N/A
27 0
28 - 30 N/A
31 0
32 - 34 N/A
35 See GPIO Flash Table
36 - 38 N/A
39 See GPIO Flash Table
40
0 to
41
214783647
42
43 1 – 8
Parm2 Description
N/A Reserved
0 Set GPIO #4 configured as Output to Low (0)
N/A Reserved
0 Set GPIO #8 configured as Output to Low (0)
N/A Reserved
0 Set GPIO #4 configured as Output to High (1)
0 Reserved
0 Set GPIO #8 configured as Output to High (1)
N/A Reserved
0 Toggle GPIO #4 configured as Output
N/A Reserved
0 Toggle GPIO #8 configured as Output
N/A Reserved
Flash GPIO #4 configured as Output (GPS LED)
N/A Reserved
Flash GPIO #8 configured as Output (GSM LED)
Generate and transmit one UDP Message to first IP address listed in
$FRIEND command and port number listed in $UDPAPI command
based on Parm1 and Parm2 values
Generate and transmit a UDP message with Acknowledge. This mes-
See Bit-Field
sage is controlled by $ACKTM command for number of retries sent.
Table
This message has to be acknowledged to avoid sending of retries.
Generate and transmit one UDP Message to all IP address lis-
ted in $FRIEND command and port number listed in
$UDPAPI command based on Parm1 and Parm2 values
Resets the timer (Timer #1 - Timer #8) specified by Parm1 to the time
(in seconds) specified by Parm2. Parm2, when set to 0, resets the
timer to the time last set by $EVTIMx command or previous output
event 43 execution.
0
A value other than 0 would set the timer to expire at the new
specified interval (e.g. xx,3,43,1,180 would set timer 1 to expire in
180 seconds). When used with a value other than 0, this is equivalent
to invoking $EVTIMx directly from the event engine and subsequent
- 347 -