At$Rtcalrm Real Time Clock Alarm - Novatel MT 3050 At Command Reference

AT$RTCALRM Real Time Clock Alarm

AT$RTCALRM
Command Function
Syntax Query
Syntax
Write Syntax
Write Response
Read Syntax
Read Response
Execute Syntax
Execute Response
Unsolicited Response
Parameter Values
< rtc_enabled >
< rtc_year >
<rtc_month>
<rtc_day>
Real Time Clock Alarm
This command handles the setting and querying of the RTC alarm
registers. When the alarm feature has been enabled the $EVENT engine will be
invoked upon the going off. If the $RTCWAKE call is invoked following the
alarm feature setup the modem will power back up automatically upon the
alarm going off. The actions of these two features are mutually exclusive of
each other, so one or the other will occur but not both.
AT$RTCALRM=?
$RTCALRM: (0-99),(1-12),(1-31),(0-23),(0-59),(0-59),(0-527040)
OK
AT$RTCALRM= <rtc_year>,<rtc_month>,<rtc_day>,<rtc_hour>,<rtc_
min>,<rtc_sec>,<rtc_alarmTimeinMinutes>
OK
AT$RTCALRM?
$RTCALRM: <rtc_enabled>,<rtc_year>,<rtc_month>,<rtc_day>,<rtc_
hour>,<rtc_min>,<rtc_sec>,<rtc_alarmTimeinMinutes>"
OK
N/A
N/A
N/A
Parameters are positional dependent, any parameter may be omitted with
the use of the comma (',') as a place holder on command line. If a parameter
is omitted then the current value in the hardware is used.
Indicates if alarm is enabled or not.
1= Enabled
0= Disabled
The year on which the alarm is being set to trigger. The RTC supports years
2000-2099. The data is entered as a two digit value 0..99.
The month on which the alarm is being set to trigger. Values range from
1..12.
The day on which the alarm is being set to trigger. Values range from 1..31.
- 190 -