Table of Contents
Advertisement
Commands
5.3.4
CHANCONFIG
This command changes the channel configuration of the receiver. This will effect the number of channels
tracking GPS signals, Galileo signals, and GEO signals. Entering this command will reset the receiver, causing
the receiver to initiate a cold-start bootup and reset all data stored in NVM to factory default values (except for
the channel configuration).
The default configuration of the EuroPak-15ab receiver is 24GALILEO8GPS.
Syntax:
CHANCONFIG
Field
Field
Name
1
header
2
config
Example:
CHANCONFIG 16GPSL1L5
16GPSL1L5
10GALILEO6GPS
16GALILEOL1E5a
8GPS8GEO
12GPS4GEOL1L5
24GALILEO8GPS
a. There are channels in the 24GALILEO8GPS configuration that can track the
GIOVE-A test satellite, see Table 59 on Page 125.
EuroPak-15ab Receiver User Manual Rev 1
CONFIG
Valid Values
This field contains the Abbreviated ASCII command name. See
Section 4.1 on Page 34.
See Table 18 below.
Table 18: Configuration Values
ASCII
8 GPS L1 + 8 GPS L5 channels
5 Galileo L1 + 5 Galileo E5a + 6 GPS L1 channels
8 Galileo L1 + 8 Galileo E5a channels
8 GPS L1 + 4 GEO L1 + 4 GEO L5 channels
6 GPS L1 + 6 GPS L5 + 2 GEO L1 + 2 GEO L5 channels
a
8 GPS L1 + 8 GAL L1 + 8 GAL E5A + 8 GAL E5B channels
Description
Specifies the channel
configuration for the receiver
to use.
Description
Chapter 5
Message ID: 501
Binary
Binary
Format
Bytes
Offset
H
0
Enum
4
H
53
Advertisement
Table of Contents
