Stream Properties Panels (Tx/Trx Modes); Stream Switcher / Stream Tiles - Lightware UBEX-PRO20-HDMI-F100 User Manual

 
     
6. Lightware Device Controller (LDC) 6. Lightware Device Controller (LDC)
6.5.5. Stream Properties Panels (TX/TRX Modes)
Clicking on the Stream 1 or Stream 2 panels on the transmitter/transceiver opens the properties of the video
input streams. The most important signal information and settings are available on the panel.
Stream 1 properties panel (TX)
Available settings and tools:
▪ Stream naming;
▪ Stream enable: when it is checked in, the stream is transmitted to the receiver; if it is not, the stream is
muted.
▪ Identify Stream / Identify Display
▪ Frame Detector;
▪ Reloading factory default settings for the selected port.
button;
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
series – Extender Application Mode – User's Manual series – Extender Application Mode – User's Manual
6.5.6. Stream Switcher / Stream Tiles
The incoming streams from the transmitter can be routed to the HDMI output 1 and/or 2 ports of the receiver.
#streamenable #switch #crosspoint
Legend of the Stream Tiles
Tile
Stream #1
192.168.0.101
Stream #1
192.168.0.101
Stream #1
192.168.0.101
Stream #1
192.168.0.101
Stream #1
192.168.0.101
Stream #1
192.168.0.101
INFO:
The maximum available bandwidth with the endpoint device is 20 Gbps which requires 2x 10 GbE
SFP+ module or DAC cable to install. If one 10 GbE SFP+ module is installed only but the signal is 4K@60
Hz (which requires ~14 Gbps to transmit), the stream tile will be yellow.
INFO:
When the signal bandwidth limit is exceeded, the stream of the HDMI in 1 on the TX side and the
stream of the HDMI out 1 on the RX side will be enabled at the expense of the HDMI in 2 / HDMI out 2. See
more information in the
INFO:
You can find the bandwidth requirements belong to each resolutions in the
the Resolutions
Selected Signal present
 
Signal is not present and stream is not selected.
 
Signal is not present but stream is selected.
 N/A
The stream is disabled and not selected.
 N/A
The stream is disabled but selected.
 
Signal is present, stream is enabled, but bandwidth is not enough for the
transmission.
 
Signal is present, stream is selected, and the bandwidth is OK.
Bandwidth Limitation section.
section.
76 76
SFP+ link
Stream enabled
bandwidth
N/A N/A
N/A N/A
 N/A
 N/A
 
 
Required Bandwidth of