Installing An Mx240 As Msc; Figure 100: Installing An As Mlc - Juniper mx240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide
Related
Documentation

Installing an MX240 AS MSC

242
CAUTION: After the
removing the AS MLC again, removing an AS MLC from a different slot, or
inserting an AS MLC in a different slot.
You can also verify correct AS MLC and AS MSC or AS MXC functioning by issuing the
and
show chassis fpc show chassis fpc pic-status

Figure 100: Installing an AS MLC

Preventing Electrostatic Discharge Damage to an MX240 Router on page 416
Replacing an MX240 AS MLC on page 305
Installing an MX240 AS MSC on page 242
Installing an MX240 AS MXC on page 243
To install an AS MSC (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Align the notches in the connector at the rear of the AS MSC with the notches in the
2.
AS MSC slot (slot 0 —the top slot in the AS MLC ), and then slide the AS MSC in until
it lodges firmly in the AS MLC.
CAUTION: Slide the AS MSC straight into the slot to avoid damaging the
components on the bottom of the AS MSC.
Use one of the following methods to bring the AS MSC online:
3.
Press the AS MSC offline/online button until the LED light turns green.
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
LED lights steadily, wait at least 30 seconds before
OK
.
SC B
SC B
Figure 101 on page 243):
Copyright © 2016, Juniper Networks, Inc.