Figure 135: Removing an AS MSC
SEE ALSO
MX480 Application Services Modular Storage Card Description | 161
Installing an MX480 AS MSC
To install an AS MSC (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Align the notches in the connector at the rear of the AS MSC with the notches in the AS MSC slot (slot
0—the top slot in the AS MLC ), and then slide the AS MSC in until it lodges firmly in the AS MLC.
CAUTION:
components on the bottom of the AS MSC.
Figure 136 on page
381):
Slide the AS MSC straight into the slot to avoid damaging the
380