Restart Communication - Lenze i55AE125B Manual

9.7.6

Restart communication

In order that the inverter can be controlled via the network, activate the network control:
0x2631:037 (P400.37) = "Network control active [114]"
Select "Network [5]" in 0x2860:001
point source. If another standard setpoint source is set, a change-over to the network setpoint
via the AC Drive control word
activated:
Change-over to network setpoint
The network setpoint is activated via bit 6 (NetRef) of the AC Drive control word:
Bit 6
0
1
Note!
In order that the activation via bit 6 works, the selection "Network setpoint active [116]" must be set in
Optionally, a change-over from the standard setpoint source to the network setpoint is also
possible via a digital input:
Set a standard setpoint source different than Network" [5]" in
•
Set the desired digital input in
•
work setpoint is to take place.
Bits 5 (NetCtrl) and 6 (NetRef) of byte 0 in the assembly output objects 21 and
23 must be transmitted to the inverter in order that control and speed reference
commands are accepted by the network.
If the network control is active
(P400.37) = 114), all bits of the AC drive control word
are processed.
If the network control is not active
0x2631:037 (P400.37)
cessed. Their states are ignored and the drive is in local control.
Parameter Name / value range / [default setting]
0x23A0 EtherNet/IP communication
(P508.00) (EtherN/IP comm.)
• From version 02.00
0 No action/no error
1 Restart with current values
2 Restart with default values
5 Stop network communication
10 In process
11 Action cancelled
12 Fault
(P201.01)to use the network generally as a standard set-
0x400B:001 (P592.01) is possible in case the network control is
Selection:
Standard setpoint source selected in
Network setpoint
0x2631:017 (P400.17) via which the change-over to the net-
(0x400B:001
(0x400B:001
= 0), the control bits 0, 1, 12, 13, 14, 15 are not pro-
Configuring the network
0x2860:001 (P201.01).
0x2631:017
0x2860:001 (P201.01).
(P592.01)/bit 5 = 1 and 0x2631:037
(0x400B:001 (P592.01))
(P592.01)/bit 5 = 0 or
Info
Restart / stop communication.
• When the device command has been executed successfully, the value
0 is shown.
• A communication restart has nothing to do with the acceptance of the
described operating modes. For this purpose, a restart of the device is
required!
Only status feedback
Restart communication with the current values.
Restart communication with the standard values.
Stop communication.
Only status feedback
EtherNet/IP
Restart communication
(P400.17).
331