Resetting Wlan Settings To Default Setting - Lenze i55AE125B Manual

Parameter Name / value range / [default setting]
0x2449 WLAN error
• Read only
• From version 02.00
Bit 2 WLAN error
Bit 3 Memory problem
Bit 4 WLAN connection problem
Bit 7 WLAN off
Bit 9 Client mode off
Bit 12 TCP/IP configuration error
Bit 13 Password length
Bit 14 Access denied
11.3.2.1

Resetting WLAN settings to default setting

Possible reasons:
Password is not known anymore.
•
WLAN SSID is not visible and not known anymore.
•
WLAN module mode "stand-alone" shall be deactivated.
•
0x2440 serves to reset all WLAN settings to the default setting. For this purpose, the inverter
must be connected to the »EASY Starter« via the USB module or an existing network.
Option 1: Reset via USB module
How to reset the WLAN settings to default setting by means of the USB module:
Requirements:
The inverter is ready for operation (supplied with voltage).
•
Required accessories:
USB module
•
USB 2.0 cable (A-plug on micro B-plug)
•
PC with installed »EASY Starter« software
•
1. Remove the WLAN module from the inverter and plug on the USB module instead.
2. Establish a connection between inverter and »EASY Starter« via the USB module.
3. Set the parameter 0x2440
4. Remove the USB module from the inverter and plug on the WLAN module instead again.
The default setting is loaded.
Option 2: Reset via network
How to reset the WLAN settings to default setting via network:
Requirements:
The inverter is ready for operation (supplied with voltage).
•
The inverter is connected to a functioning network.
•
Required accessories:
PC with installed »EASY Starter«. Moreover, the PC must be connected to the network
•
which also implements the inverter.
1. Establish a connection between the inverter and »EASY Starter« via the used network.
2. Set the parameter 0x2440
The default setting is loaded.
to "Restart with default values [2]".
to "Restart with default values [2]".
Additional functions
Info
Bit coded display of WLAN errors.
Wireless LAN (WLAN)
WLAN basic settings
429