Diagnostics - Lenze i55AE125B Manual

9.8.5

Diagnostics

The parameters for diagnosing the network are described below.
Parameter Name / value range / [default setting]
0x23B2:001 Active Modbus TCP settings: Active IP address
(P511.01) (Act. MBTCP sett.: Act. IP address)
• Read only
• From version 04.00
0x23B2:002 Active Modbus TCP settings: Active subnet
(P511.02) (Act. MBTCP sett.: Act. subnet)
• Read only
• From version 04.00
0x23B2:003 Active Modbus TCP settings: Active gateway
(P511.03) (Act. MBTCP sett.: Act. gateway)
• Read only
• From version 04.00
0x23B2:005 Active Modbus TCP settings: MAC address
(P511.05) (Act. MBTCP sett.: MAC address)
• Read only
• From version 04.00
0x23B3 Switch position
(P509.00) (Switch position)
• Read only
• From version 04.00
0x23B5:001 Active port settings: Port 1
(P513.01) (Act. port sett.: Port 1)
• Read only
• From version 04.00
0 Not connected
1 10 Mbps/Half Duplex
2 10 Mbps/Full Duplex
3 100 Mbps/Half Duplex
4 100 Mbps/Full Duplex
0x23B5:002 Active port settings: Port 2
(P513.02) (Act. port sett.: Port 2)
• Read only
• From version 04.00
0 Not connected
1 10 Mbps/Half Duplex
2 10 Mbps/Full Duplex
3 100 Mbps/Half Duplex
4 100 Mbps/Full Duplex
0x23B8 Modbus TCP module status
(P516.00) (MBTCP modul. stat)
• Read only
• From version 04.00
0 Power off
1 Initialization
2 Warning
3 Fault
4 No configuration
5 Operational
Configuring the network
Info
Display of the active IP address.
Display of the active subnet mask.
Display of the active gateway address.
Example
The setting 276344004 corresponds to the gateway address
196.172.120.16.
• 276344004 = 0x1078ACC4 à 0xC4.0xAC.0x78.0x10 = 196.172.120.16
Display of the active MAC address.
Display of the rotary encoder switch setting at the last mains power-on.
Display of the baud rate set for the port 1 in parameter
(P512.01).
Display of the baud rate set for the port 2 in parameter
(P512.02).
Display of the TCP module state.
Modbus TCP
Diagnostics
0x23B4:001
0x23B4:002
353