5.5
Save parameter settings in the memory module
5.5.1
Save parameter settings with keypad
If one parameter setting has been changed with the keypad but has not been saved in the
memory module with mains failure protection, the SET display is blinking.
In order to save parameter settings in the user memory of the memory module, press the key-
pad enter key longer than 3 s.
VEL
: FLEX: AIN1
0 0 0
S T O P
REM
AUTO
SET
5.5.2
Save parameter settings with »EASY Starter«
If a parameter setting has been changed with the »EASY Starter« but not yet saved in the
memory module with mains failure protection, the status line of the »EASY Starter« displays
the note "The parameter set was changed".
In order to save parameter settings in the user memory of the memory module,
click the button in the toolbar of the »EASY Starter«
•
press the function key <F6> or
•
execute the device command "Save user data":
•
Saving Parameters
S A V I N G P
REM
AUTO
> 3 s
or
0x2022:003 (P700.03)
Commissioning
Save parameter settings in the memory module
Save parameter settings with »EASY Starter«
Parameters S aved
P S A V E D
S
SET
= "On / start [1]".
REM
AUTO
SET
107