Quick Start Parameter Settings; Basic Parameter Settings - Lenze ESV251 1S Series Operating Instructions Manual

SMV Quick Start Guide
1.1

Quick Start Parameter settings

1.1.1

Basic Parameter settings

The SMVector drives can run a motor right out of the box using the onboard Keypad! Below are a few
parameters that should be considered when trying to run using the onboard keypad.
Code
No. Name
P100
Start Control
Source
P101
Standard
Reference Source
Minimum Output
P102
Frequency
Maximum Output
P103
Frequency
P104 Acceleration Time
P105 Deceleration Time
Motor Overload
P108
Protection
Base Voltage
P165
Base Frequency
P167
64
Possible Settings
Default Selection
0
0 Local keypad
0
0 Keypad
Set this to the minimum frequency
0
you need for the application
Set this to the maximum frequency
60
you need for the application
Set the required acceleration time
20s
needed for the application
Set the required deceleration time
20s
needed for the application
Calculate P108 = (motor rated
100% current/SMV output current rating
x100 (found on pages 9-11)
Base voltage and base frequency are the main
parameters for scaling the V/Hz curve (see
graphic on right). The base voltage (P165)
is the AC voltage output voltage at the drive's
base frequency (P167). For a typical setup
in the US, this comes with default values for
whatever voltage the drive's rated for to run a
60Hz motor that provides full output voltage
based on the incoming line voltage minus
some loses.
IMPORTANT
Run/stop button on front of drive
(default no change necessary out of box)
Speed/torque reference from keypad buttons
(default no change necessary out of box)
This parameter is used to protect your motor and
controls. Full load amp rating of the motor should
match the output amperage rating of the motor.
Going below 30% is not recommended (i.e. 3amp
motor and 10amp drive).
U
100%
P168
Lenze SMVector 13554876 EDBSV01 EN v21.0
P167
F