Milling Simulation 3D Graphic; Measuring Cycle Support In The G Code Editor - Siemens SINUMERIK 840D sl Commissioning Manual

08/2005
4.13.3

Milling simulation 3D graphic

This function is a software option named "Milling Simulation", with order number
6FC5253-0AE02-0AA0.
If the option is set, the "3D Simulation" softkey will appear and can be used to
select the function.
Operation of milling machine simulation is described in:
References:

4.14 Measuring cycle support in the G code editor

In HMI Embedded you can integrate screen forms, which provide for programming
measuring cycles, into the G code editor. These cycles can then be recompiled
automatically.
The "measuring cycles" function is a software option with order no.
6FC520-0BX00-0AB0.
For further information about measuring cycle support, please refer to:
References:
•
In the ANWENDER-ZYKLEN\COMMON.COM file, remove the semicolon ";" in
front of the following lines:
;SC326 = AEDITOR.COM ;Turning measuring cycles (horizontal softkey 6 on
;SC327 = AEDITOR.COM ;Milling measuring cycles (horizontal softkey 7 on
In this way, you establish the connection between the softkeys, with which you
call the measuring cycle support, and the configuration file of these support
screens.
•
In the ANWENDER-ZYKLEN\COMMON.COM file, remove the semicolon ";" in
front of the following line:
;SC617 = STARTUP.COM ;Startup operating area (horizontal
In this way, you can change the properties of the measuring cycle support in
the "Startup" operating area.
Change the properties of the measuring cycle support in the "Startup" " >"
"Measuring Cycles" menu.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
/BEM/ Operator's Guide HMI Embedded
/BNM/ User's Guide Measuring Cycles
;the extended softkey bar in the G code editor)
;the extended softkey bar in the G code editor)
;softkey 7 on the extended softkey bar
;in the G code editor)
Starting Up HMI Embedded (IM2)
4 Functions/Parameterization
IM2/4-57