Siemens SINUMERIK 840D sl Commissioning Manual page 164

Expanding the Operator Interface (BE1)
7 Configuring and Working Environment
Example of COMMON.COM
[MMC_DOS]
sc101=tooth.com
sc111=mda.com
sc122=auto.com
sc207=param.com
sc314=aeditor.com
sc315=aeditor.com
sc316=aeditor.com
sc407=dienste.com
sc507=diagnose.com
sc607=inbetrn.com
sc826=cmm.com
sc857=cmm.com
sc858=cmm.com
sc867=cmm.com
LAN1=stdlan1.com
LAN2=_N_stdlan2_com ; Background language on NC
CHK_COMMON.COM=1
LOGSIZE=30
[PLC_SELECT]
PC1= CYC82, drilling.com
PC2= CYCLE90, millthre.com ; display 2
Displays, which can be called from the PLC
If displays are to be called from the PLC on the basis of Expand user interface,
then it is necessary to create a section [PLC_SELECT].
This section is for assigning the display numbers to the configured displays. In
general, the syntax of an assignment line is:
PCi = display name, file
i
Screen name
File
Example:
[PLC_SELECT]
PC1= CYC82, drilling.com
PC2= CYCLE90, millthre.com
PC3=..., etc.
In the complete example shown above, the section [PLC_SELECT] is at the end of
Common.com.
BE1/7-158
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
; MACHINE
; Files are located in the
; Flash memory of the HMI
; PARAMETER
; PROGRAM, Editor
; SERVICES
; DIAGNOSTICS
; Start-up
; ShopMill, Machine, AUTO
; Messages/
; Alarms
; Tools, ZO
; Configured form texts
; are in stdlan1.com in the
; Flash memory
; faster processing
; by HMI
; 30 kB for LOG of errors in
: the screen forms
; declaration of
; displays that can be called from
; the PLC, see below.
; display 1
;Comment
Number of the display in the interface
Display (screen form) identifier
File in which the display is configured
;Fixed section introduction
;Assignment line
© Siemens AG, 2005. All rights reserved
08/2005