Siemens SINUMERIK 840D sl Commissioning Manual page 185

08/2005
Term
Machine data
Main body of screen
form
ManualTurn
Master screen form
Method
NC
NC code
NC function
Parameters
Parts program
PI service
PLC
Programming support
system
RECALL key
Register
Retranslation
Screen form
Screen form definition
block
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
Explanation
Settings of properties of the SINUMERIK system made by
Siemens/machine manufacturer/end user and stored in the system.
The following types of auxiliary function are available:
$MN_... General NC machine data
$MC_... Channel-specific machine data
$MA_... Axis-specific machine data
$MM_... Machine data of operator panel front
In addition to this there is → setting data and drive machine data.
Header, long text, graphics and → Screen form elements
Optimized SINUMERIK application and user interface for simple
turning machines.
→ Screen form, which calls another screen form but remains open
when a second screen is displayed.
Programmed sequence of operations, which is executed when a
corresponding → Event occurs.
Numerical Control: System component of a SINUMERIK system,
which controls the motional sequences of axes on the basis of →
Parts programs.
Permissible language elements used to write → Parts programs of
the SINUMERIK system
→ PI service
Parameters are variable elements of the programming syntax and
replaced by other words/symbols in the → Configuration file.
A program formulated in the NC language, which specifies motion
sequences for axes and various special actions.
→ Function, which, on an → NC, executes a clearly defined
operation.
PI services can be called from the → PLC and → HMI
Advanced/HMI Embedded.
Programmable Logic Control: Programmable controller, which
performs mainly logic operations in the SINUMERIK system.
Provision of → Screen forms to assist programmers in writing →
Parts programs with "higher-level" components
Free contour programming
Cycle support
Blueprint programming
→ Retranslation
→ Simulation
directly from the → Editor.
Standard key on front of operator panel
Memory for data exchange between → Screen forms.
Sections of → NC code can be generated in a → Parts program
from input fields in → Screen forms of the → Programming support
system. Recompilation is the reverse operation. The input fields,
which have created a selected section of NC code, are retrieved
from the NC code and displayed in the original screen form.
Screen display of → User interface
Program section from //M..........//END for defining a → Screen form
Expanding the Operator Interface (BE1)
8 Terms, Tables, Lists, Examples
BE1/8-179