Software Version Display - Siemens SINUMERIK 840D sl Commissioning Manual

Commissioning cnc part 2 (hmi)

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Starting Up HMI Embedded (IM2)

8 Diagnostics

If the bit is already set when HMI Embedded is booted, HMI Embedded does not

respond to the value of the bit (only after it has been reset and set again).

The log file _AC_LOGP.TXT is read out either during the boot process or can

be read out in the Diagnosis operating area until the system is next switched

off. The file is then deleted.

Reboot of the control with

Prompt: "Action log detected! Read out CF-Card? ([Y]/N)"

Acknowledge with "Yes"; the log file is now saved on the CF card.

A latency must be observed between two signals to make sure that the second

signal can be processed.

8.2 Software version display

The version data of the installed system software are output

in the version display.

• Select the "Diagnostics" operating area

• Select the "Service displays" softkey

• Select the "Version" softkey

You can display the version data of the following areas via the horizontal softkeys:

Version data of the NCU

Version data of the HMI

Version data of the cycles (user, manufacturer, standard cycles)

Compile cycles

SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition

Table of Contents