Configuring The "Exit" Softkey - Siemens SINUMERIK 840D sl Commissioning Manual

Commissioning HMI Advanced (IM4)
2 Functions/Parameterization

2.4.13 Configuring the "EXIT" Softkey

Application
If you want the sequence control of the HMI software to support an "EXIT" softkey,
you should make the following settings:
[Miscellaneous]
ExitButton=True
ExitButtonIndex = index
The text for identifying the softkey text must be entered in
F:\mmc2\language\re_xx.ini
ExitButtonAccessLevel=7
ExitButtonQueryUser = True
Requesting a RESTART after shutdown (for Windows XP only)
This function enables HMI Advanced (including Windows XP) to be shut down
followed by a reboot of the PCU during the setup phase. This enables you to avoid
switching the PCU or machine on and off.
The following settings are required:
[Miscellaneous]
EnableRebootDialog=True
The entry can be set either directly in the INI file or by means of the user interface
via Start-up → HMI → Settings → HMI Exit Mode. If the "EXIT" menu is configured
accordingly, the "Shutdown... " or "Restart ... " prompt appears depending on the
access stage.
•
If the protection level is lower than the manufacturer level (protection level 2
to 7) or if the above entry is set to "False" in the REGIE.INI file, the prompt
can be confirmed with:
OK
Cancel
•
If you have the applicable access authorizations (protection level 2 to 7), the
following option is offered:
Restart
Exit
Cancel
IM4/2-76
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
where xx is the language identifier.
; Dialog box to ask user
HMI is closed and Windows XP is shutdown.
HMI is not closed
HMI and Windows XP are closed and then
restarted.
HMI is closed and Windows XP is shutdown.
HMI is not closed
© Siemens AG, 2005. All rights reserved
08/2005