Coordinate Systems; Actual Value Display; Position Of Coordinate System - Siemens SINUMERIK 840D sl Commissioning Manual

Starting Up HMI Embedded (IM2)
4 Functions/Parameterization

4.15 Coordinate systems

4.15.1

Actual value display

Via the display machine data MD 9424: MA_COORDINATE_SYSTEM you can set
whether
•
the position of the workpiece coordinate system (programmed position,
corresponds to the default setting) or
•
the holding position of the active tool relative to the workpiece zero must be
shown in the actual-value display.
MD 9424
MD 9424
References:
4.15.2

Position of coordinate system

The display machine data MD 9650: CMM_POS_COORDINATE_SYSTEM is used
to set the position of the coordinate system for milling.
Table 4-3
9650 MD number
Default setting 0
Data type BYTE
Meaning
Note
The display machine data MD 9610: CTM_POS_COORDINATE_SYSTEM is
used to set the position of the coordinate system for milling.
References:
IM2/4-58
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
= 0 Display in workpiece coordinate system, WCS
(default)
= 1 Display in settable zero system, SZS
(take-up position of active tool)
/FB1/K2: Axes, Coordinate Systems, Frames,...External Work
Offset
Machine data 9650
CMM_POS_COORDINATE_SYSTEM
Position of coordinate system
Min. input limit: 0
With this machine data you adapt the coordinate
system of the user interface to the coordinate system
of the machine.
The coordinate system can assume the following
positions.
/FB1/K1: Mode group, channel, program operation mode
Unit: -
Valid as of SW release:
SW 05.01.13
© Siemens AG, 2005. All rights reserved
08/2005