Siemens SINUMERIK 840D sl Commissioning Manual page 510

Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
;
;LINK=TC_DPC7
;
; MD 18096: $MN_MM_NUM_CC_TOA_PARAM=7
; MD 18097: $MN_MM_TYPE_CC_TOA_PARAM[7]=4
; MD 18080: $MN_MM_TOOL_MANAGEMENT_MASK='H4'
;
LINK=0
; example data sets
[500.1]
tool_type=500
insert_length=
holder_angle=
reference_direction=
clearance_angle=
[500.2]
tool_type=510
insert_length=
holder_angle=
reference_direction=
clearance_angle=
[520.1]
tool_type=520
insert_length=
reference_direction=
[530.1]
tool_type=530
insert_length=
reference_direction=
[540.1]
tool_type=540
reference_direction=
[160.1]
tool_type=160
tip_angle=
;TC_DPV3=
;TC_DPV4=
;TC_DPV5=
IM4/2-116
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
; example LINK=TC_DPCS1
; unique identifier (t,d) for roughing tool 1
; tool type, if not set, $TC_DP1 is
; used
; TC_DP8, insert length
; TC_DP10, holder angle
; TC_DP11, cutting direction
; TC_DP24, clearance angle
; unique identifier (t,d) for finishing tool 1
; tool type, if not set, $TC_DP1 is
; used
; TC_DP8, insert length
; TC_DP10, holder angle
; TC_DP11, cutting direction
; TC_DP24, clearance angle
; unique identifier (t,d) for plunging tool 1
; tool type, if not set, $TC_DP1 is
; used
; TC_DP8, insert length
; TC_DP11, cutting direction
; unique identifier (t,d) for parting tool 1
; tool type, if not set, $TC_DP1 is
; used
; TC_DP8, insert length
; TC_DP11, cutting direction
; unique identifier (t,d) for thread-cutting tool 1
; tool type, if not set, $TC_DP1 is
; used
; TC_DP11, cutting direction
; unique identifier (t,d) for boring-threading-
; milling cutter
; tool type, if not set, $TC_DP1 is
; used
; TC_DP10, tip angle
; 1=+X; -1=-X
; 1=+Y; -1=-Y
; 1=+Z; -1=-Z
© Siemens AG, 2005. All rights reserved
08/2005