Network Configuration - Siemens SINUMERIK 840D sl Commissioning Manual

Starting Up HMI Embedded (IM2)
3 Communication/Initial Requirements
The following methods can be used to create the connections:
Type
No drive
Local USB
USB global
Flash Card
NW Linux
NW Windows
• A numeric setting for DOS (Windows) is made in the "Partition" field.
• Two lines, with a maximum of nine characters each, are available for the
softkey text.
• You must allocate a user name and a password for Windows shares.
If no setting is entered, a default user (PCU20_USER) is entered and a default
password is used.
• No user names or passwords are needed for Linux (NFS) shares and
local/global network paths (USB).
• The first four softkeys for the configured connections are displayed in the
horizontal menu bar in the "Program" and "Services" operating areas, and the
other four softkeys are displayed in the second horizontal menu bar, which can
be opened using the ETC key ">".
• The selection of the drive can be prevented by setting the appropriate access
level.

3.3.2 Network configuration

Settings
The data required for networking the components are entered in the "Network
Configuration" window.
Only the TCP/IP protocol is supported and can be configured within the network
setup screens.
IM2/3-20
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
Connection Path (path entry)
- -
Front acttcu://0,2
(preassigned) acttcu://2
X203 acttcu://1
X204
X203 Connection to other TCUs
X204
.../user/sinumerik/data/...
- // Linux ComputerName/Linux
ShareName
- // WindowsComputerName/
WindowsShareName
CompactFlash
card in the NCU
© Siemens AG, 2005. All rights reserved
08/2005