Siemens SINUMERIK 840D sl Commissioning Manual page 521

08/2005
Define memory and type for SIEMENS-OEM parameter $TC_DPCS1
$MN_MM_NUM_CCS_TOA_PARAM=1
$MN_MM_TYPE_CCS_TOA_PARAM[0]=4
Or
Define memory and type for USER-OEM parameter $TC_DPC1
$MN_MM_NUM_CC_TOA_PARAM=1
$MN_MM_TYPE_CC_TOA_PARAM[0]=4
3. Set up SimToGeo.ini:
Define link entry for Siemens or User OEM parameter and expand geometrical
data.
This is done using the OEM variable ($TC_DPCS1/$TC_DPC1).
The value of this variable determines the geometrical block that is used.
For example, the entry for tool 1 cutting edge 1 (T1D1) $TC_DPCS1[1,1]=500.1
would be referred to the geometrical data block [500.1] in the SimToGeo.ini file.
It is possible for more than one tool to refer to the same geometrical data block.
Add expanded geometrical tool data.
This in done in blocks, which are distinguished by float number identifiers, for
instance. For example [500.1].
[Settings]
Link=TC_DPCS1
;Link=TC_DPC1
[500.1]
tool_type=500
insert_length=10
holder_angle=105
reference_direction=3
clearance_angle=5
4. Link to tool data/TO_INI.INI:
CHANDATA(1)
$TC_DPCS1[1,1]=500.1 ; Siemens OEM T1 D1 roughing tool SL3 type 500
;$TC_DPC1[1,1]=500.1 ; User OEM
$TC_DP1[1,1]=500
$TC_DP2[1,1]=3
$TC_DP3[1,1]=100
$TC_DP4[1,1]=55
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
; Link to TO_INI.INI, Siemens OEM
; Link to TO_INI.INI, USER OEM
;T1 D1 Roughing tool type500 SL3 L1=100, L2=55, R1
;Tool type then $TC_DP1 not required
;TC_DP8, insert length
;TC_DP10, holder angle, not rake angle
;TC_DP11, cutting angle
;TC_DP24, clearance angle
Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
; TC_DPCS1 is reserved
; Data type Float for
; TC_DPCS1
; TC_DPC1 is reserved
; Data type Float for TC_DPC1
IM4/2-127